2/19/2023 0 Comments Uefitool linuxWe use the following source repositories in this guide: Project This section of the guide shows you how to set up the environment on either a Linux or Windows development PC before starting to build EDKII firmware. You also need to follow the instructions in Set up the development environment. How to install git is shown in the following code: $ sudo apt install git Check that these requirements are in place before you follow the instructions in that section of the guide.īefore you work through any section of the guide, you must have git installed. Each section contains its own software and hardware requirements. They all show you how to build firmware on different platforms, so you may not need to read and work through each section. There are four different sections in this guide. Have the required EDKII firmware binaries for following the tutorials that are found in Next steps to run the firmware on an FVP or Arm Juno development platform.Be able to build the reference firmware for FVP and the Arm Juno development platform.Be familiar with the EDKII development and build environment.UEFI Forum develops and maintains the specifications. EDKII is an open-source project that provides a feature-rich, cross-platform firmware development environment for UEFI and UEFI Platform Initialization (PI) specifications. The TianoCore EFI Development Kit II (EDKII) project provides an implementation of the UEFI firmware. UEFI also defines run-time services, for example, time, variable that an OS can invoke at runtime. UEFI defines the firmware interfaces and boot services that are required for booting a standards-based OS. UEFI is a specification that defines an interface between the firmware and an Operating System (OS). If you have a Windows system installed, you can check the controller ID using Device Manager.Ĭheck under Storage Controllers -> HighPoint NVMe RAID Controller, and view the Properties for this entry.This guide shows you how to build Unified Extensible Firmware Interface (UEFI) firmware for the Arm Fixed Virtual Platform (FVP) Model and Juno Development Platform on either a Linux or Windows development PC. The items highlighted in red below file indicate that the SSD7000 controller was recognized by the motherboard, and the driver loaded normally: This will save the data to the USB boot drive, as “ pci.txt”:Į.You can now check the contents of the drivers.txt and pci.txt that were saved to the USB flash drive. Type PCI and press Enter to view the NVME SSD’s connected to the SSD7102, as shown below:ĭ.Save the on-screen driver information using the following command: This will save this data to the USB drive, as the file “ drivers.txt”.Ĭ. Save the driver information that is displayed on the screen using the following command: After booting the system to the USB flash drive, type the following command and press Enter:ī.If the controller is detected, but the “No Supported Controller Detected” is still displayed when attempting to create an array, you will need to make sure the controller ID matches the product ID. Check the Software Updates webpage for the SSD7000 controller you are working with, and see if any updates are available.Ĥ. Make sure you are using the correct and latest version of the UEFI utility.Consult your motherboard’s User Guide, and check the motherboard’s UEFI BIOS settings – make sure Option ROM settings are enabled for the PCIe slot used by the controller.A loose/insecure connection would prevent the controller from being detected by the motherboard. Make sure the SSD controller is properly installed into the PCIe slot.There is a UEFI version error (you are using an incorrect our outdated version of the UEFI tool).The SSD controller is not securely installed into the motherboard’s PCIe slot.The SSD7103/7202/7505 controller is not functioning properly.When attempting to create a RAID array using the UEFI tool, the interface reports that “No Supported Controller Detected”, and can proceed no further. The UEFI Utility Reports No Supported Controller Detected
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |